To configure an access port on a Huijue switch, assign the port to a VLAN, set it as an access type, enable the port, and optionally apply security and QoS settings.

Step-by-Step Configuration

1. Access the Switch CLI
   • Connect via console cable or SSH.
   • Enter system view mode using system-view to start configuration .
2. Create VLANs
   • Define the VLANs needed for your network:

     vlan batch 2 3

   • This creates VLAN 2 and VLAN 3 for use on access ports .
3. Configure the Access Port
   • Enter the interface configuration for the target port:

     interface ethernet 2/0/1

   • Set the port type to access:

     [Switch-Ethernet2/0/1] port link-type access

   • Assign the default VLAN:

     [Switch-Ethernet2/0/1] port default vlan 2

   • Activate the port:

     [Switch-Ethernet2/0/1] undo shutdown

   • Exit interface configuration:

     [Switch-Ethernet2/0/1] quit

4. Optional Security Settings
   • Enable port security to prevent unauthorized devices:

     [Switch-Ethernet2/0/1] port-security enable[Switch-Ethernet2/0/1] port-security mac-address sticky

   • Apply rate limiting to control bandwidth:

     [Switch-Ethernet2/0/1] qos lr outbound cir 100000

   • Use ACLs to restrict traffic to trusted IP ranges:

     acl 3000

5. Save Configuration
   • Ensure changes persist after reboot:

     save

Best Practices

• Always verify VLAN membership and port type to avoid connectivity issues .
• Use port security and ACLs to protect against unauthorized access .
• For voice or video traffic, configure QoS to prioritize critical packets .
• Avoid leaving unused ports enabled to reduce security risks . By following these steps, your Huijue switch access ports will be properly configured for secure and efficient network connectivity, supporting end devices while maintaining VLAN separation and traffic control.