To connect a router to a Huijue fiber optic line, you must first use the Optical Network Terminal (ONT) provided by your ISP, then link it to your router via Ethernet.

Step 1: Gather Necessary Equipment

• Optical Network Terminal (ONT): This device converts the fiber optic signal into an electrical signal your router can use, and is usually provided by Huijue or your ISP .
• Fiber optic cable: Typically single-mode with SC/APC or SC/UPC connectors.
• Router: Ensure it has a WAN or Internet port compatible with Ethernet input.
• Ethernet cable: Cat6 or higher is recommended for optimal speeds .

Step 2: Install the ONT

1. Locate the fiber optic wall outlet where the Huijue fiber line enters your home.
2. Connect the fiber optic cable from the wall outlet to the ONT's optical port. Handle the connector carefully to avoid dirt or damage .
3. Power on the ONT and wait for the status lights to stabilize, indicating a successful connection to the fiber network .

Step 3: Connect the ONT to Your Router

1. Use an Ethernet cable to connect the ONT's LAN or Ethernet port to the WAN/Internet port on your router .
2. Power on the router and wait for the indicator lights to confirm a successful connection.

Step 4: Configure Your Router

• Access the router's settings via a web browser using its IP address (usually printed on the router).
• Follow the setup wizard to configure your Wi-Fi network, including SSID and password.
• Change default login credentials to secure your network .

Step 5: Verify the Connection

• Check that the ONT's PON/Optical light is solid green or blue, indicating an active fiber link .
• Run a speed test to ensure your internet connection is performing as expected.
• If issues arise, ensure all cables are securely connected and the ONT is powered on before the router . By following these steps, your router will be successfully added to the Huijue fiber optic network, providing high-speed internet throughout your home or office.